NTC Blog

Code Question – Network Smoke Detection

Thu, Sep 17 2020 at 12:00 AM

Code Question: “Does the Annex A recommendation for locating a smoke detector not closer than 3 feet from a supply or return air opening also apply to air-sampling network smoke detection?”

 

An air sampling-type smoke detector, commonly called an aspirating smoke detector, uses piping to draw air from a protected space back to a sensing chamber for detection. Modern air sampling detectors typically use a photoelectric type detection to provide high sensitivity detection.

 

Air sampling detectors sometimes get confused with duct smoke detectors. While both may use “tubes” for detection, they are completely different types of detectors. Duct smoke detectors are designed to detect smoke in the HVAC system with the primary purpose of HVAC shutdown to prevent the spread of smoke. Duct detectors may be mounted in the duct but are primarily mounted externally and use sampling tubes with holes in them that extend into the duct to sample the air in the duct.

 

Air sampling detectors use piping run through the protected area with sampling port holes in the pipe. The piping system is connected to an aspirating fan that draw air into the piping and transports it to the detection unit which detects smoke or other fire products.

 

 

17.7.3.6.1 of NFPA 72 requires that each sampling port be treated as a spot-type smoke detector for purposes of location and spacing (unless performance based design criteria has been applied). The airflow produced by the system fan is not enough to significantly effect smoke flow around the protected space, so sampling ports must be treated as a passive device like a spot type smoke detector.

 

NFPA 72, 17.7.4 states that spaces served by air handling systems shall not locate detectors where airflow prevents operation of detectors. Annex A, A.17.7.4, recommends that detectors not be located in the direct airflow or closer than 36 inches from air supply diffuser or return air opening. This recommendation is intended to prevent airflow from diluting smoke or delaying smoke reaching the detector, both of which can significantly delay detection.

 

It is important to note that this is recommendation Annex A material, which makes it a “should” (recommendation, but not a requirement). The recommendation should be accommodated if reasonable, but not meeting the recommendation does not violate the requirements of the code.


Subscribe to the NTC Blog

Sign Up to Get Specials & Training Updates